[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [N8VEM-S100:5257] Re: finished case with SMB installed

If you haven't made large holes before, be careful not to let the file slip from the hole- it really can mess up your panel!
Speaking from experience..


-----Original Message-----
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of Philippe Elie
Sent: Tuesday, September 23, 2014 1:29 AM
To: n8vem...@googlegroups.com
Subject: Re: [N8VEM-S100:5257] Re: finished case with SMB installed

Hi Mark, I drilled four holes, one at each corner, to insert a fretsaw and get an first approximate rectangular hole. I then simply finished the shape with a flat file. Make sure you drill the holes and use the saw 2 to 3 mm within the shape to avoid getting "outside"... Good luck

You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.