Yes Todd from Arrow. They are specked as 5V but the seem to work OK at 3.3V. John From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of geka...@gmail.com John - Todd just a quick note to let you know the V06c version of the mezzanine boards checked out fine on the 16MG S100 RAM board. I hammered them fairly good with the 80386 board, they did fine. Soldering the chips on to the board is quite tricky. I found it best to aligen one corner, then orientate the chip and do the diagonally opposite corner, then run the salder tip along the pins. With a wet tip there is enough solder on the pins and the board for contact. However I had one chip where the pin did not make contact, took me a while to locate it. These boards are definatly not for anybody with shakey hands Will next do the 32MB 80386 board, but for now I feel confident sending them out to all 16MB board users. Thanks Andrew and Dave for all your help on these. John -- |