Yes Todd from Arrow. They are specked as 5V but the seem to work OK at 3.3V.
From: n8ve...@googlegroups.com [mailto:n8vem...@
googlegroups.com] On Behalf Of gek...@gmail.com
Sent: Wednesday, July 23, 2014 6:26 AM
Subject: [N8VEM-S100:4675] Re: S-100-16M-SRAM-MEZZ-V6c Board - Status --- OK
I assume this was with the CY62167ELL-45ZXI ram?
Let the group know when you're ready to ship out a few!
On Tuesday, July 22, 2014 9:09:44 PM UTC-4, monahanz wrote:
Todd just a quick note to let you know the V06c version of the mezzanine boards checked out fine on the 16MG S100 RAM board. I hammered them fairly good with the 80386 board, they did fine.
Soldering the chips on to the board is quite tricky. I found it best to aligen one corner, then orientate the chip and do the diagonally opposite corner, then run the salder tip along the pins. With a wet tip there is enough solder on the pins and the board for contact. However I had one chip where the pin did not make contact, took me a while to locate it. These boards are definatly not for anybody with shakey hands
Will next do the 32MB 80386 board, but for now I feel confident sending them out to all 16MB board users.
Thanks Andrew and Dave for all your help on these.
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@
For more options, visit https://groups.google.com/d/