RE: [N8VEM-S100:2391] ZFDC Bringup

["John Monahan" <mon...@vitasoft.org>]

Pete, the drive number is set by the onboard Z80. Go to the command/monitor
mode and see if you can output u11, bits PB0  & PB1.  If not, bend up u11
pins and retry. In this fails probably bad PIO.
John


-----Original Message-----
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On
Behalf Of Pete Plank
Sent: Wednesday, February 12, 2014 4:47 AM
To: n8vem...@googlegroups.com
Subject: [N8VEM-S100:2391] ZFDC Bringup

Hi all,

I'm attempting to bring up a ZFDC card and I believe I have it mostly there.
I burned an EEPROM with the ZFDC.HEX file and now the first two TIL-311A
displays (track number) are counting from 0-FFh as expected. The next two
displays are both "0" (sector number) and the final display is stuck on "3"
(drive number).

Try as I might, I can't seem to get the drive number display to show a "0"
as per the build document. Jumper settings don't seem to help so far; I
expect I may have a bad chip someplace. Has anyone run into this behavior
before?

Thanks much,

Pete

-- 
You received this message because you are subscribed to the Google Groups
"N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an
email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.