Re: CF Images for the Dual IDE/CF

Thanks Gary,

I checked the schematic and I understand what you did. Now I do remember reading about the issue. I just discovered that I am not able to access the second CF card B. According to the schematic U15 is used for the selection. Maybe I need to make the modification to add a small delay?

For now however the CF card A is being accessed okay. I think the port address is correct since I am getting activity on the CF, but getting "boot error" when I try option "P" from the menu. I tried downloading the CF image but so far I don't think I am doing it correctly. I will try again and let you know my progress.

Thanks for your help,

Harold

On Tuesday, June 30, 2015 at 9:35:25 AM UTC-4, hlr...@gmail.com wrote:

Hi Everyone.

I have been building up a system with the Z80 board, 4MB memory board, Dual IDE/CF, and the prop I/O. I have finished this and am using the V5.02 ROM on the Z80. The system boots up to the menu. However I can't do very much except check memory and display.

Now I want use my V2 Dual IDE/CF to boot up CP/M. Unfortunately the link on s100computers for the jumper and switch setup is not working! I was wondering what people use for settings on SW1, SW2. I think I have jumpers K1 and K5 set okay.

I also found a thread about CF images for the IDE/CF board, but the date was several years ago. Is there a location where I can copy a disk image for CP/M? I have the Kingston 4GB CF.

Any help would be great!

Thanks
Harold