Re: [N8VEM-S100:4276] Re: A windows based program to write a CPM3 image to a CF card for the S100 IDE board

John,

Never mind I found it - It is in the MSDOS link. Simple enough to patch in to my code - I will make A & B be the 2 IDE drives and users can add ZFDC, etc beyond that. That will give the most basic common configuration for users. I am going to allow the tool to build 4 different types of images. 1. Non banked serial I/O, 2. Non banked prop con 3. Banked serial I/O 4: Banked prop con. I will also provide a bat file if you drop in your own CPMLDR.COM and CPM3.SYS it will build the disk image using those instead of the pre-built ones. That should give the most flexibility to all.

Dave

On Thursday, June 19, 2014 12:42:04 PM UTC-5, yoda wrote:

John

Which link at the bottom - I think I tried the most current HMAKECPM ABCD Banked but I did not see it - I will look again - but if you can tell me which link then it would be easier.

Dave

On Thursday, June 19, 2014 11:36:00 AM UTC-5, monahanz wrote:
Hi Dave, I think I now have the dual IDE drive support updated. I have it in two places ate the bottom of each page:-
http://s100computers.com/Software%20Folder/CPM3%20BIOS%20Installation/CPM3%20HDISK%20BIOS%20Software.htm

and here:-
http://s100computers.com/My%20System%20Pages/IDE%20Board/My%20IDE%20Card.htm

If you notice any other errors please let me know

Thanks
John

From: n8ve...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of yoda
Sent: Wednesday, June 18, 2014 6:52 PM
To: n8ve...@googlegroups.com
Cc: mon...@vitasoft.org
Subject: Re: [N8VEM-S100:4276] Re: A windows based program to write a CPM3 image to a CF card for the S100 IDE board

Hi John

Status update and a couple of questions. I have both banked and non banked working with s100 serial I/O card and IDE. I will finish my prop console this weekend so I can test that version. I noticed that none of the source files you have support both ports of the IDE. I think that would be useful to people so I will look at adding the second drive - does not look too hard to do. I am a little reluctant to build images that support floppy as there probably not as many people that have the ZFDC board running (I don't) and it will hang if it doesn't find one. I will have writeup on how to extend making other types of images. Basically if you drop in a cpmldr.com and a CPM3.sys into the directory and run a bat file it will make an image for you. So for the adventurous that should be a reasonable solution. Any comments?

Dave
--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.