Sorry frank I’m a bit confused as to what you are doing. The ZFDC.HEX file is in the .zip file. Can you not burn it into a PROM from the HEX file
The SLR Z80 Assembler is supplied here:-
http://s100computers.com/Software%20Folder/Assembler%20Collection/Assembler%20Collection.htm
I assume by now you know how to use the SIMH Altair Simulator to run the assembler on your PC.
If not see here:-
http://s100computers.com/Software%20Index%20Page.htm
John
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of Frank Schieschke
Sent: Friday, August 1, 2014 1:26 AM
To: n8vem...@googlegroups.com
Subject: [N8VEM-S100:4768] Re: ZFDC Controller under control of the PC-BIOS??
Yesterday i build the Prop I/O board to exchange my CompuPro Interfacer1 board.
The Prop I/O works at once, but the problem with the ZFDC controller is the same.
I used the newest firmware for the ZFDC controller i get from the website.
But i have no possibility at the moment to compile a defined new one.
I use the TASM cross assembler for the 8080 and Z80 code.
To use TASM with the given source code, there are a lot of syntax changes to do.
I am going the next days to fit the source for TASM.
Frank
--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.