Thanks Gary,
I think I'll pick up one of the programmers from Ebay, it will be useful if I want to play with the code.
regards
David
On Saturday, September 26, 2015 at 8:32:17 PM UTC+1, Gary Kaufman wrote:
David -
Jim Orchard is also in the UK (at least by his email address).
I purchased this PICkit3, but would tell you the ZIF board included was
useless with the PIC32 (at least I couldn't get it working and there was
Zero documentation). The ICSP cable worked fine with a breadboard.
http://www.ebay.com/itm/141636162194?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
A bunch of vendors in Hong Kong or China have them for less than $15
I used the PICkit3 "Header with self power supply" on this site for
actually burning. I just set it up on a temporary breadboard and used
an LM317 circuit and 9V battery.
https://sites.google.com/site/pcusbprojects/5-custom-projects/r-pickit-3-header-for-pic32mx250f128b-programming
Again, happy to burn them and include them in a shipment to Jim if he's
ok with that.
- Gary
On 9/26/2015 3:19 PM, David Fry wrote:
> Hi Gary,
>
> good point,
> can you post a link to the programmer you purchased on ebay ?
>
> Also, I think I might be the only one in the UK
>
> regards
>
> David