[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [N8VEM-S100:2560] Re: Board Run: Unbuffered Prototyping
I would pull that top row of holes; you're going to be way too close to the edge. Sometimes the DRC is there for a reason... A lot of the design rules are ones that PCB manufacturers will also call out because they can drastically reduce yield. Holes that close to the edge are likely to end up cut through if the board is misregistered at all, and a lot of board houses don't like you putting the pads so close to the edge either.
- Dave
On Feb 28, 2014, at 3:44 AM, Crusty OMO <crus...@hotmail.com> wrote:
> I don't know if the .pdf made it... let's try inline picture....
> <SeaoPTH.JPG>