The 03 is the currently selected drive I seem to remember, but check
John
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of Gary Kaufman
Sent: Friday, August 15, 2014 7:28 PM
To: n8vem...@googlegroups.com
Subject: Re: [N8VEM-S100:4947] Re: ZFDC Controller under control of the PC-BIOS??
Success!!!
I haven't had time for any extensive testing, but was able to boot to a prompt. What a great feeling :)
One curiosity is that the V2.9 ZFDC.HEX file cleared the display to "00000" and then began rolling the first two digits. This later V3.5 ZFDC.HEX leaves a "3" in the far right digit. I'll have to look thru the code, but is this an error message?
John (and Frank), thanks so much.
- Gary
On 8/15/2014 3:59 PM, John Monahan wrote:
That’s great news Frank! Gary, how about you?
John
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of Frank Schieschke
Sent: Friday, August 15, 2014 12:39 PM
To: n8vem...@googlegroups.com
Subject: [N8VEM-S100:4937] Re: ZFDC Controller under control of the PC-BIOS??
Hello John,
Thanks for the version 3.5 that you published on your site.
I just burn the EEPROM.
And now i am able to boot MS-DOS (in my case 3.3) from the floppy disk.
Frank
--
--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.