[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [N8VEM-S100:5836] FP Mini Group NKK Switch Group - Complete



Thanks Don.  Dumber, me.  Hadn't connected that page with "Wiki" in my mind.  Who reads GUIs anyway ...

On Mon, Dec 15, 2014 at 10:57 AM, Don Caprio <ilv...@gmail.com> wrote:
It's on the N8VEM Wiki. Near the bottom of the Front page
there is a section for S-100 boards. Board 16 is the front panel.

http://n8vem-sbc.pbworks.com/w/browse/#view=ViewFolder&param=S-100%20FPMini



On 12/14/14 11:32 PM, Paul Birkel wrote:
Just color me dumb, Don.  Where is the FP Mini Wiki that you mention?

On Thu, Dec 11, 2014 at 4:20 AM, Don Caprio <ilv...@gmail.com> wrote:

Attention FP Mini builders

    ...

If you've been watching the Wiki, I do regret that the RUN and HALT
LED's got swapped. You have two choices here. Change the silkscreen,
or wait for a fix. I attempted some jump and cut and borked my
board. Luckly I was able to restore and got it operational again. I do have
a fix that does not require cuts and jumpers. It's a bit cheesy so I'm
reluctant to share at this point. Basicaly involves placing tape over the
component holes and using the long LED leads to reach the proper holes.

I am planning on a V2 board. It will have the LED fix, all jumpers moved
to a dip switch on top of the board and line drivers for the S100 bus signals
which should allow the board to run better at higher speeds. It's going to be
tricky finding real estate for the extra components, but I'm up for the
challenge.

Thank you all for supporting this project.

    ...
-- 
Don Caprio
ilv...@gmail.com
--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.

-- 
Don Caprio
ilv...@gmail.com

--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.