Probably because the code was not yet written Frank. If you are able to read both sides with the 0E & 0F commands then your hardware is probably OK.
Take a look at the source to check however
John
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of Frank Schieschke
Sent: Wednesday, July 16, 2014 12:49 AM
To: n8vem...@googlegroups.com
Subject: [N8VEM-S100:4609] Re: Get the ZFDC controller to format a disk...
Hello John,
i notice while testing, that the ZFDCDIAG program subroutines 11 & 12 (R/W tests) only uses one side of the disk.
On the screen the side changed between A & B, but not on the hardware.
The read tests 0E & 0F are working with two sides.
Is there a reason for?
Frank
--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.