Frank if you do dig deep it would be great to get the propeller assembly modules for displaying the PC keyboard scan code on the HEX display. I have the ASCII code working but could not figure out where to pick up the scan codes in the assembly modules. It’s a specialized language and will take quite a bit of reading to figure out.
John
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On Behalf Of Frank Schieschke
Sent: Thursday, August 21, 2014 10:43 AM
To: n8vem...@googlegroups.com
Subject: [N8VEM-S100:4983] Re: Prop I/O board - Cursor control and special functions
Thanks David,
for the interesting link.
This should be an good base for the ANSI-Terminal.
Now i have to go further in the propeller programming.
Just another language to produce programming bugs. 8-)
Frank
--
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.