RE: [N8VEM-S100:5278] TIL311 displays for S100-IDE board

["John Monahan" <mon...@vitasoft.org>]

Ian you could try using a small red panel plastic window in front of them
all. In fact that is what I did for my SMB with the front panel.  The red
light shines through, nothing else
John


-----Original Message-----
From: n8vem...@googlegroups.com [mailto:n8vem...@googlegroups.com] On
Behalf Of Ian McLaughlin
Sent: Monday, September 29, 2014 1:16 PM
To: n8vem...@googlegroups.com
Subject: [N8VEM-S100:5278] TIL311 displays for S100-IDE board

Hello all,

I'm in the millde of building the S100-IDE board to drop in to my NorthStar
Horizon.  The final pieces showed up today, but there's a bit of a problem,
and wondering if anyone else has seen this?

I acquired 10 TIL311 displays from an eBay seller but when they arrived,
they have an obvious gouge on the display surface that has been filled in
with a black marker.  All 10 of them.  To me it looks like factory seconds
that were marked with a gouge.

Here's a picture:

https://www.dropbox.com/s/j8lmciw8n9kys13/IMG_3182.jpg?dl=0

Has anyone else seen these displays like this?  I've filed a dispute with
the seller because they are nothing like the condition of the picture in the
auction.  I'll give them a go, but esthetically they're terrible.

Any suggestions on an inexpensive source for these displays in
non-gouged-and-filled-in state?

Thanks.

Ian

-- 
You received this message because you are subscribed to the Google Groups
"N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an
email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.