[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [N8VEM-S100:6993] Question about the S100 4Meg memory board

I've always used 1K SIP's, works fine.

- Gary

On 5/10/2015 5:27 PM, hlrjr via N8VEM-S100 wrote:

I am currently building the S100 4Meg static memory board. I believe that this board came out several years ago, but I am fairly new and catching up.

Anyway the circuit has listed a 10 pin resistor network with a value or 1100 ohm. I have not been able to find that value. I have plenty of 1K resistor networks, so I was wondering if anyone could advise me on using the 1K instead of the 1.1K. I looked at the schematic and it appeared that the resistors were being used to tie down pins on one of the switches.

Any help?

You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.