|
Hey Don!
I'd be interested in getting 2 as well. Thanks, Matt Turner > Date: Sun, 7 Dec 2014 20:40:35 -0800 > From: ilv...@gmail.com > To: n8vem...@googlegroups.com > Subject: Re: [N8VEM-S100:5777] NKK Switches for Mini FP > > Folks are starting to get the switches for the FP mini board and asking > about > a switch bracket. > > The switch bracket has two important purposes. One is for the > positioning of the > switches when you solder them in. I've tried doing this without a > bracket and it's > very difficult to get them lined up perfect without some sort of jig. > > I already have a quote from sheet metal fabricator here in town to > produce one. > In small quantities it was $15 USD. > > I'm thinking that I can do these on my mill, probably five or six at a > time for just the > cost of materials. I already have drill bits and tap for the tiny > screws. I'm going to give it > a try this week. > > If your interested in a bracket please let me know so I can gage the > interest level. > > We may be to produce a few and pass them onto other builders on a 'loaner' > basis. However my original plan was to use the bracket for installation > and as a > strain relief in the chassis. > > Please feel free to send along your ideas and suggestions. > > Thank you. > > > On 12/ 7/14 03:17 PM, G. Beat wrote: > > Before I setup the bench for assemblying this board, later this month, > > Did someone develop a switch frame (or std. Process) for maintainibg alignment, as I solder these switches? > > > > -- > Don Caprio > ilv...@gmail.com > > -- > You received this message because you are subscribed to the Google Groups "N8VEM-S100" group. > To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com. > For more options, visit https://groups.google.com/d/optout. |