Great job, Don!
Can't wait to complete mine. I'll surely buy a couple of V2 when you'll complete them.
Attention FP Mini builders
All switch orders have been shipped today. I apologize for the
delay in shipping. Year end crunch at the office and labor
involved in putting these shipments together got the best of me.
I had nearly 1000 switches to sort through, count, recount, and
package. I did my best to get orders correct. If you find extra
switches or are missing some please let me know. I have a nagging
fear a couple could have got mixed up. Joe got Sam's order and
If you've been watching the Wiki, I do regret that the RUN and HALT
LED's got swapped. You have two choices here. Change the silkscreen,
or wait for a fix. I attempted some jump and cut and borked my
board. Luckly I was able to restore and got it operational again. I do have
a fix that does not require cuts and jumpers. It's a bit cheesy so I'm
reluctant to share at this point. Basicaly involves placing tape over the
component holes and using the long LED leads to reach the proper holes.
I am planning on a V2 board. It will have the LED fix, all jumpers moved
to a dip switch on top of the board and line drivers for the S100 bus signals
which should allow the board to run better at higher speeds. It's going to be
tricky finding real estate for the extra components, but I'm up for the
Thank you all for supporting this project.
Here is a list of folks who were shipped switches. If you ordered some and
your name is not on the list please contact me.
-- Don Caprio ilv...@gmail.com
You received this message because you are subscribed to the Google Groups "N8VEM-S100" group.
To unsubscribe from this group and stop receiving emails from it, send an email to n8vem-s100+...@googlegroups.com.
For more options, visit https://groups.google.com/d/optout.